Installing the left thrust field
- Position the left thrust field (4)
- Replace screws (2) and (3)
Parts: Screws
- Screw in screws (2) and (3) a few turns
- Tighten screws (arrows)
TIGHTENING TORQUE SPECIFICATION
| Thrust field to body | ||
|---|---|---|
| M8 | Tightening torque | 28 Nm |
- Tighten the screws (2)
TIGHTENING TORQUE SPECIFICATION
| Thrust field to outer body | ||
|---|---|---|
| M10 Replace screw |
Tightening torque | 56 Nm |
| Angle of rotation | 90° | |
- Tighten down screw (3)
TIGHTENING TORQUE SPECIFICATION
| Thrust field to door sill | ||
|---|---|---|
| M12 Replace screw |
Tightening torque | 100 Nm |
| Angle of rotation | 90° | |
- Replace nut (1)
Parts: Nut
- Tighten nut (1)
TIGHTENING TORQUE SPECIFICATION
| Thrust field to rear axle support | ||
|---|---|---|
| M10 Replace nut |
Tightening torque | 56 Nm |
| Angle of rotation | 90° | |
Follow-up work
- Refer to INSTALLING THE CONNECTING SUPPORTS ON THE TUNNEL .
- Refer to INSTALLING TANK COVER .