Removing the pedal mechanism
- Instructions for Manual transmission vehicles
CAUTION:
Materials harmful to health
Contact with fluids harmful to health!
Contact with fluids harmful to health!
- Note and follow safety instructions on containers
- Conduct all work in appropriate personal protective equipment only
Preliminary work
- Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
- Refer to REMOVING THE TRIM PANEL FOR PEDAL ASSEMBLY .
- Refer to REMOVING THE CLUTCH MASTER CYLINDER .
- Insert release tool 2 409 646 in the arrow direction between the brake pedal and the brake booster
- Set support (1) of release tool 2 409 646 on the bearing bracket. If necessary, position the support by twisting the screw on the release tool tightly
- Press release tool 2 409 646 in the arrow direction and lever out the brake pedal from the brake booster
- Loosen screw (2)
- Release nuts (3)
- Remove pedal mechanism (1)