Installing the bearing bracket for the pedal mechanism
- Install bearing bracket (2)
- Replace the screw (1)
Parts: Screw
- Position and tighten the screw (1)
TIGHTENING TORQUE SPECIFICATIONS
| Pedal bracket on body | ||
| M8 Replace screw |
tightening torque | 22 Nm |
- Replace nuts (1)
Parts: Nuts
- Install the nuts (1) and tighten
TIGHTENING TORQUE SPECIFICATIONS
| Brake booster to pedal assembly console Replace nuts |
||
| M8 Retighten 1x on brake booster after 10 min |
tightening torque | 22 Nm |
NOTE:
The following step(s) must be performed if the listed component(s) is/are installed
- Connect connector (1)
NOTE:
The following step(s) must be performed if the listed component(s) is/are installed
- Connect connector (1)
- Lock brake pedal (1) in place in the arrow direction with the brake booster
Make sure that the brake pedal is completely locked with the brake booster!
Follow-up work