Replace the holder for the PDC/PMA/side view camera (2' Series coupe and convertible, 2017-2021)
Necessary preliminary work:
- If necessary, remove the side view camera or ultrasonic sensor. Refer to 66 33 010 REMOVING AND INSTALLING/REPLACING ULTRASONIC SENSORS FOR PARKING MANOEUVRING ASSISTANT .
Observe NOTES for bonding with adhesive tape.
The description of the work uses the example of a PDC holder.
If necessary, completely remove the faulty holder and adhesive residue.
Lightly sand the adhesive area (1) with sandpaper.
Clean the adhesive area (1).
Insert the ultrasonic sensor (1) in the holder (2).
CAUTION:
Mount holder (2) according to its installation position. Note the label on the holder (2).
Align the visible notch (3) with the mark (4) and bond the holder (2) with the integrated ultrasonic sensor (1).
Apply primer 770 all round on holder (2) and on bumper panel in area (5).
Fasten holder (2) with ADHESIVE K6 on bumper panel.