Remove the wiring harness section for sensor system 2
Preliminary work
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING THE LEFT COVER IN THE ENGINE COMPARTMENT .
- Refer to REMOVING THE RIGHT COVER IN THE ENGINE COMPARTMENT .
- Refer to REMOVING THE TENSION STRUT ON THE STRUT TOWER .
- Refer to REMOVING THE SOUND INSULATION ON THE ON THE CENTER OF THE FIREWALL UPPER PART .
- Refer to REMOVING ACOUSTIC COVER AT REAR .
- Refer to REMOVING THE INTAKE FILTER HOUSING .
- Refer to REMOVING CLEAN AIR PIPE .
- Refer to REMOVING CHARGE AIR LINE .
- Refer to UNINSTALLING THE COVER FOR THE DME CONTROL UNIT .
- Refer to DISCONNECTING THE CONNECTOR FROM THE DME CONTROL UNIT AND FROM THE POWER DISTRIBUTION BOX (PDM) .
Wiring harness section for sensor system 2
Precondition
- Loosen screw (1) .
- Disconnect the tank ventilation line (2) from the intake plenum.
- Loosen screws (3) .
- Unlock and pull off the connector of the DME control unit.
- Unlock and remove the connector of the integrated supply module (PDM).
- Unlock and disconnect the connector of the Valvetronic servomotor.
- Unlock and disconnect the connector of the camshaft sensor of the intake camshaft.
- Unlock and pull off the camshaft sensor connector of the exhaust camshaft.
- Unlock and disconnect the connector of the rail pressure sensor.
- Unlock and pull off the connector of the hot film air mass meter.
- Pull off the connector of the front oxygen sensor.
- Unlock and pull off the connector of the monitoring oxygen sensor.
- Unlock and pull off the high pressure pump connector.
- Unlock and disconnect the connector of the heating element on the vent hose.
- Unlock and disconnect the connector of the electric controller drive for the wastegate valve controller.
- Unlock and pull off the connector of the VANOS solenoid actuator.
- Detach the wiring harness section (1) from the clamps.
- Remove the wiring harness section (1) .