51 43 070 Removing and installing/replacing side trim panel, footwell, on A-pillar, left (2' Series coupe and convertible, 2017-2021)

Necessary preliminary tasks: 

• Refer to REMOVING FRONT DOOR SILL COVER STRIP (INSIDE) .
• Refer to REMOVING TRIM PANEL FOR PEDAL MECHANISM .

Detach edge protection (1) in area of side trim panel (2).

Release screw (3).

Remove engine compartment lid release lever (4) from side trim panel (2).

Installation note: 

Make sure edge protection (1) is correctly seated.

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Unclip side trim panel (3) in direction of arrow from retaining points (2).

If necessary, disconnect associated plug connection and remove side trim panel (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

If necessary, lever out clamps (1) remaining in bore.

Replace faulty clips (1).

Position side trim panel (2) pre-installed with clips (1) on associated bore holes and clip into place.

Replacement: 

Modify REAR LID UNLOCKING SWITCH , if applicable.

Courtesy of BMW OF NORTH AMERICA, INC.