Installing air duct to radiator
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Perform the steps on the right and left side.
- Feed in air duct to radiator (2) with bracing strut (3).
- Tighten the screws (1).TIGHTENING TORQUE SPECIFICATIONS
Air duct to deformation element M6x20 screw Tightening torque 4.6 Nm - Tighten down screw (1).TIGHTENING TORQUE SPECIFICATIONS
Bracing strut to top front bumper support or to top connection M6x20 screw Tightening torque 11.8 Nm - Tighten down screws (2).TIGHTENING TORQUE SPECIFICATIONS
Air duct to cross connection M6x20 screw Tightening torque 11.8 Nm
Follow-up work
- Refer to INSTALLING THE INTAKE MANIFOLD FOR THE INTAKE FILTER HOUSING .
- Refer to INSTALLING THE BUMPER CARRIER IN THE FRONT TOP .
- Refer to INSTALLING IMPACT ABSORBER .
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to INSTALLING TEMPERATURE SENSOR .
- Refer to PARTIALLY INSTALLING FRONT LEFT AND RIGHT WHEEL ARCH COVER .
- Refer to PARTIALLY INSTALLING THE WHEEL ARCH TRIM ON THE FRONT LEFT AND RIGHT .
- Refer to INSTALLING THE FRONT CENTER HOOD SEAL .
- Refer to INSTALLING HOOD SEAL ON LEFT AND RIGHT SIDES .
- Refer to CONNECTING THE BATTERY EARTH LEAD .