Removing the crankshaft sensor
Precondition
- Ignition is switched off.
Preliminary work
- Refer to REMOVING THE FRONT UNDERBODY PROTECTION .
- Refer to REMOVING REAR UNDERBODY PROTECTION .
- Refer to REMOVING THE SUPPORT FOR THE UNDERBODY PROTECTION .
- Refer to REMOVING THE PROTECTIVE PLATE FOR THE FUEL LINES .
NOTE:
RISK OF DAMAGE
Electrostatic discharge.
Damage to or destruction of electrical components.
Electrostatic discharge.
Damage to or destruction of electrical components.
- Leave the electrical components in their original packaging until they are being installed. Only use the original packaging for returning the product. Always package removed components straight away.
- Read and comply with user information on using the associated special tool 12 7 060.
- Only tap the housings of electrical components. Do not tap pins or multi-pin connectors directly.
- Wear electrically conductive clothing and antistatic shoes (with ESD symbol).
- For additional information see: 61 35... Notes on ESD (electrostatic discharge) protection
- Unlock plug connection (1) and disconnect.
- Loosen screw (2).
- Guide out and remove crankshaft sensor (3).