Remove the rear active stabilizer
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
WARNING:
Vehicle may slip off the vehicle hoist if the vehicle hoist is handled incorrectly.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- Observe safety instructions on raising the vehicle using a vehicle hoist.
- For additional information see: RAISING THE VEHICLE WITH A VEHICLE LIFT .
Preliminary work
- Refer to REMOVING THE REAR RIGHT WHEEL .
- Refer to REMOVING THE COVER OF THE CAMBER CONTROL ARM ON THE LEFT AND RIGHT .
- Refer to REMOVING THE UNDERBODY PLANKING OF THE TRANSMISSION ON THE SIDE .
- Refer to REMOVING TANK COVER ON LEFT AND RIGHT .
- Refer to REMOVING CENTER STIFFENING PLATE .
- Refer to REMOVING THE REAR DIFFUSER .
- Refer to IF INSTALLED: REMOVING THE REAR AXLE COVER .
- Refer to REMOVING COMPLETE EXHAUST SYSTEM .
- Refer to LOOSENING THE ANTI-ROLL BAR LINK ON THE ANTI-ROLL BAR ON THE LEFT AND RIGHT .
- Refer to DISCONNECTING THE WIRING HARNESS OF THE REAR ACTIVE STABILIZER .
- Release the bolt (1) and detach the cable clip (2) from the right-hand retainer.
NOTE:
TECHNICAL INFORMATION
Secure component against falling.
Secure component against falling.
- Loosen screws (2).
- Remove active stabilizer (1).