Installing rear torsion strut
- Insert and install the torsion strut (3) on the right.
- Replace screws (2).
Parts: Screws
- Tighten down screws (2).TIGHTENING TORQUE SPECIFICATIONS
Torsion strut to mounting M12 Replace screws. Tightening torque 100 Nm Angle of rotation 90° - Tighten nut (1).TIGHTENING TORQUE SPECIFICATIONS
Torsion strut to mounting M10 tightening torque 56 Nm Installing tank cover
- Feed in and position the tank cover (2).
- Tighten all bolts and nuts (arrows).
- Tighten down screws (1).TIGHTENING TORQUE SPECIFICATIONS
Undershield screw Tightening torque 2.6 Nm Plastic nut Tightening torque 2.6 Nm