Shifting vehicle into normal position
- In vehicles with air suspension systems: Perform ride height adjustment with diagnostic system.
- Check vehicle interior and trunk (including luggage compartment well) for load status, if applicable, unload vehicle.
- Lay prescribed DIN load into the vehicle.
TECHNICAL DATA SPECIFICATION
| DIN normal position loading | ||
|---|---|---|
| Vehicle has a full tank. Vehicle is completely assembled. Per front seat (seat in center position) |
68 kg | |
| On the center rear seat | 68 kg | |
| Centered in the trunk | 21 kg | |
- In vehicles with air suspension systems:
After the vehicle has been loaded, start the engine and wait until the vehicle ride height has been adjusted.NOTE: (The doors must be closed)