Install the retainer of the anti-roll bar
NOTE:
TECHNICAL INFORMATION
Do not mix up the left and right!
Do not mix up the left and right!
- When assembling the retainer (1), it is essential to note the installation position!
L = left retainer
R = right retainer
F = driving direction
NOTE:
TECHNICAL INFORMATION
Do not use lubricant or a installation aid between the anti-roll bar and the rubber mount.
Do not use lubricant or a installation aid between the anti-roll bar and the rubber mount.
- Coat the outer sides of the rubber mounts with lubricant.
CONSUMABLE SPECIFICATION
| Installation aid (Circo Light; lubricant) | 250 ml, Bottle | 83192405829 |
- Position the retainer (3) on the anti-roll bar (2).
- Replace screws (1).
Parts: Screws
- Tighten down screws (1).
TIGHTENING TORQUES SPECIFICATION
| Retainer, anti-roll bar to rear axle support | ||
|---|---|---|
| M10 Replace screws. |
tightening torque | 56 Nm |