Replacing the left cylinder head cover

• Remount clamps (1)  on the cylinder head cover (2)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Loosen screws (2)  .
• Remove camshaft position sensors (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

Check 

• Check O-rings (1)  on the camshaft position sensors for damage.

Courtesy of BMW OF NORTH AMERICA, INC.

Result 

» O-ring (1)  damaged.

Measure

• Replace O-ring (1)  .

  Parts:  O-ring

Result 

» O-ring (1)  not damaged.

Measure

• Continue the repair.

• Coat O-ring of camshaft position sensor with engine oil.
• Position camshaft position sensors (1)  .
• Tighten down screws (2)  .
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Camshaft position sensor to cylinder head cover
  Torx screw M6	Tightening torque	8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Loosen screws (1)  .
• Remove liquid-vapor separator (2)  .
• Position the liquid-vapor separator (2)  .
• Tighten down screws (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.