Install the sealing cap on the cylinder head of cylinder bank 1
- Replace the seal (1)
.
Parts: Seal
- Position the sealing cap (2) on the cylinder head.
- Tighten down screws (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Timing case cover on cylinder head | ||
| M6x20 screw | Tightening torque | 9.5 Nm |
Follow-up work
- PARTIALLY INSTALLING THE GUIDE TUBE FOR THE OIL DIPSTICK .
- INSTALLING THE RIGHT-HAND CHARGE AIR COOLER .
- INSTALLING THE COOLANT EXPANSION TANK FOR THE LOW-TEMPERATURE COOLANT CIRCUIT (CHARGE AIR COOLER) .
- SEALING OFF COOLANT FOR LOW-TEMPERATURE COOLANT CIRCUIT .
- INSTALLING FRONT STIFFENING PLATE AND/OR UNDERBODY PROTECTION OF THE STEERING GEAR .
- REMOVING THE UNDERBODY PROTECTION OF THE STEERING GEAR AND THRUST FIELD RESPECTIVELY .
- INSTALLING FRONT UNDERBODY PROTECTION .
- CONNECTING THE LEFT CHARGE AIR LINE TO THE EXHAUST TURBOCHARGER .
- INSTALLING FAN COWL .
- INSTALLING THE REAR TOP CROSS CONNECTION .
- INSTALLING UPPER CROSS CONNECTION .
- INSTALLING BOTH FRONT-END STRUTS .
- INSTALLING THE CENTER ENGINE COMPARTMENT COVER .
- FILLING AND VENTING THE LOW-TEMPERATURE COOLANT CIRCUIT .