Installing the rear silencer
- Insert rear silencer (3) and install.
- Tighten nuts (2).
Parts: Nuts
TIGHTENING TORQUES SPECIFICATIONRear silencer to body/bumper support M8
Replace nuts.Tightening torque 19 Nm - Connect and lock the connector (1).
The connector (1) must engage audibly.
- Connect the rear silencer to the center silencer with gripper clamps (1).
- Center the gripper clamps (1) and tighten the nuts (2).TIGHTENING TORQUES SPECIFICATION
Clamp with partial replacement of exhaust system Clamp Tightening torque 45 Nm