Installing both sport leather steering wheel switches
NOTE:
The operations shown only for one side must be carried out on both sides.
- Position the switch (2) on the design trim and tighten with screws (1).TIGHTENING TORQUES SPECIFICATION
MFL switch Screw TS5x12 tightening torque 1.5 Nm - Connect connectors (3) and lock.
Follow-up work
- Refer to INSTALLING THE DECORATIVE TRIM FOR THE SPORTS STEERING WHEEL (SA255) .
- Refer to INSTALLING THE DECORATIVE TRIM FOR THE M SPORT STEERING WHEEL (SA710) .
- Refer to IF INSTALLED: INSTALLING THE SHIFT PADDLE FOR THE AUTOMATIC TRANSMISSION .
- Refer to INSTALLING THE AIRBAG UNIT (SPORTS STEERING WHEEL) .
- Refer to INSTALLING THE AIRBAG UNIT (M SPORT STEERING WHEEL) .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .