Installing the rear power distribution box

NOTE: Schematic diagram is for example purposes. Some parts may differ in certain details.

Tighten nut (2).

TIGHTENING TORQUES SPECIFICATION

Positive battery cable
Flange nut M8	tightening torque	15 Nm

Close the cover (1).

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
Fuses can be pushed out of their correct end positions when connecting the connectors.
While connecting the connector, counter support it against the fuse side.
After locking the connector, check if the fuse layout is complete and ensure the correct end position of the individual fuses.
Connect all connectors and lock.
NOTE: TECHNICAL INFORMATION
Attention! Wiring harnesses must be laid and fixed in such a way that no tensile loads act on the wiring harness and its plug connections.
Position the wiring harness (1) in such a way that there is no tensile load on the connector and wiring harness.

Courtesy of BMW OF NORTH AMERICA, INC.
Feed in the new cable ties (1) through both of the openings on the power distribution and tighten them.

Courtesy of BMW OF NORTH AMERICA, INC.
Check all fuses for their correct end position and lock them in place correctly.

Courtesy of BMW OF NORTH AMERICA, INC.
Position the power distribution (2) correctly and engage it into the holder (3).
Detents (1) must engage correctly.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work