Installing rear door window glass (fixed)

• Carefully feed in the door window glass at the rear (1) down into the door and position correctly on the window regulator (2).

  Make sure that the window slot cover strip inside is not damaged.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Make sure the rear door window glass is secure (1) on the window slot cover strip (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten the screws (2).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Stationary side window to window regulator
  Nut, self-locking	tightening torque	9.5 Nm

• Install seal plug (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten nut (2).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Stationary side window to window regulator
  Nut, self-locking	tightening torque	9.5 Nm

• Install seal plug (1).
• Remove the yellow plastic adhesive tape on the outside of the window cavity.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to ADJUSTING THE FIXED REAR DOOR WINDOW GLASS .
• Refer to INSTALLING REAR DOOR TRIM PANEL .
• Refer to ATTACHING THE REAR OUTER WINDOW RECESS FINISHER STRIP .