Remove the bellows of the central mount
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
Preliminary work
- Refer to REMOVING THE CONNECTING SUPPORT FROM THE TUNNEL .
- Refer to REMOVING THE TORSION STRUT ON THE REAR LEFT AND RIGHT .
- Refer to REMOVING THE REAR DIFFUSER .
- Refer to REMOVING COMPLETE EXHAUST SYSTEM .
- Refer to REMOVING TRANSMISSION CROSS-MEMBER .
- Refer to REMOVING THE HEAT SHIELDS .
- Refer to REMOVING THE COMPLETE PROP SHAFT .
- Detach the bellows (1) from the groove (2).
- Identify the installation position of the prop shaft (3) and the rear prop shaft (4) in a plane.
The identification makes it possible for the front and rear prop shaft to be installed in the same position. This ensures that the prop shaft is balanced again in the section after installation.
- Pull the prop shaft apart in the direction of the arrow.
- Release the bellows (1) out of the groove (2) using a screwdriver and detach via the longitudinal splines.