Replacing the radial shaft seal for the left or right drive flange
Remove the radial shaft seal
- Prepare the special tool 0 490 466 (00 5 010)
with the special tools 0 494 649 (21 2 230)
(without the screw) and 0 493 384 (11 1 212)
.
- Pull out and remove the radial shaft seal (1) with the special tools 0 490 466 (00 5 010)
, 0 494 649 (21 2 230)
, and 0 493 384 (11 1 212)
.
- Replace radial shaft seal at front.
Parts: Radial shaft seal
Installing the installation protection ring of the radial shaft seal
NOTE: TECHNICAL INFORMATION
Radial shaft seal ring are equipped with an installation protection ring. The installation protection ring is used to protect the sealing lip when installing the output shaft. - Install the radial shaft seal (2) using the installation protection ring (1).
Install the radial shaft seal
- Coat the housing of the sheet metal flange of the radial shaft seal with approved rear differential fluid.
- Strike in the radial shaft seal with the matching special tool 0 495 860 (33 5 130) or 0 495 862 (33 5 140) up to the stop.
- Remove the special tool 0 495 860 (33 5 130)
or 0 495 862 (33 5 140)
.