Adjust Front Door
Preliminary work
Follow-up work
NOTE:
TECHNICAL INFORMATION
The gap dimensions form the basis for these repair instructions and must be observed without fail.
For additional information see: 41 00... Gap dimensions for body
The gap dimensions form the basis for these repair instructions and must be observed without fail.
For additional information see: 41 00... Gap dimensions for body
Check
- Check gap dimension between front door and the adjacent body parts.
Result
» Gap dimensions do not correspond to the specifications.
Measure
- Adjust the front door.
- Open the front door.
- Slacken screws (1) until the front door can be shifted.
- Adjust the height (Z) of the front door.
- Adjust the width (Y) of the front door.
- Tighten down screws (1).TIGHTENING TORQUES SPECIFICATION
Front door to door hinge screw Tightening torque 19 Nm Adjust lock striker
Precondition
The screws on lock striker are loosened so far that the lock striker can still be shifted.
NOTE: TECHNICAL INFORMATION
The gap dimensions form the basis for these repair instructions and must be observed without fail.
For additional information see: 41 00... Gap dimensions for body - Adjust the height of the lock striker so that the door lock does not bump or drag.
- Shift the lock striker sideways to adjust the gap dimension (protrusion) of the door.
- Tighten down screws (1).TIGHTENING TORQUES SPECIFICATION
Lock striker screw Tightening torque 21 Nm