Install The Outer Section Of The A-Pillar

NOTE: TECHNICAL INFORMATION
Use only approved spot welder for repair.
For additional information see: 41 00... Workshop equipment

Pre-clean the bonded rivet connection (1) with cleaning agent R2.
CONSUMABLE SPECIFICATION

Cleaning agent R2 500 ml 83190417324
Clean the bonded rivet connection (1) with cleaning agent R1.
CONSUMABLE SPECIFICATION

Cleaning agent R1 100 ml, Bottle 83192211217

Courtesy of BMW OF NORTH AMERICA, INC.
Apply adhesive K1 to bonded rivet connection (1).
ADHESIVE SPECIFICATION

Body adhesive K1 195 ml 83190413015

NOTE: TECHNICAL INFORMATION
For additional information see: 41 00... Installation of cavity sealing (expanded)
Apply sealant D1 to the cavity sealing elements (2).
CONSUMABLE SPECIFICATION

Sealant D1 (seam sealing) 310ml 83422409985
Install the new part and the reinforcement plates.
Set in the area (1) blind rivet N7.
CONSUMABLE SPECIFICATION

Blind rivet N7
'0 6.5 mm; clamping area 1.5 - 3.5 mm 83192240352
Weld the new part and reinforcement plate in areas (2) to (4) as per new part preparation process.
In the areas (2) and (3), hereby observe the procedure for replacing spot-welded adhesive joints from standard production.

Courtesy of BMW OF NORTH AMERICA, INC.
Weld the new part and reinforcement plate in areas (1) and (2) as per new part preparation process.
In the area (2), hereby observe the procedure for the replacement of spot-welded adhesive joints for the standard production.

Courtesy of BMW OF NORTH AMERICA, INC.