Installing The Left Luggage Compartment Floor
NOTE:
TECHNICAL INFORMATION
Use only approved spot welder for repair.
For additional information see: 41 00... Workshop equipment
Use only approved spot welder for repair.
For additional information see: 41 00... Workshop equipment
- Pre-clean bonding surfaces on vehicle and on new part with cleaning agent R2.CONSUMABLE SPECIFICATION
Cleaning agent R2 500 ml 83190417324 - Clean bonding surfaces on vehicle and on new part with cleaning agent R1.CONSUMABLE SPECIFICATION
Cleaning agent R1 100 ml, Bottle 83192211217 - Apply adhesive K5 to the bonding surfaces.ADHESIVE SPECIFICATION
Body adhesive K5 50 ml 83192158654 - Install the new part and rivet in areas (1) to (4) with blind rivets.
Area Blind rivet 1 N1 2 N2 3 N1 4 N3 CONSUMABLE SPECIFICATIONBlind rivet N1
Ø 6.5 mm; clamping area 2.8-4.8 mm83190301414 CONSUMABLE SPECIFICATIONBlind rivet N2
Ø 6.5 mm; clamping area 4.8-6.8 mm83190301419 CONSUMABLE SPECIFICATIONBlind rivet N3
Ø 4 mm; clamping area 1-3 mm83190301421 - Rivet the new part in the area (2) with blind rivets N2.CONSUMABLE SPECIFICATION
Blind rivet N2
Ø 6.5 mm; clamping area 4.8-6.8 mm83190301419 - Weld the new part in the area (1) according to the new part preparation process.
Avoid applying too much heat to the adjacent adhesive area (2).
- Weld the new part in the area (1) according to the new part preparation process.