Install rear brake pad wear sensor

Install the brake pad wear sensor (2) in the brake pad in the direction of the arrow.
Ensure correct fit of brake pad wear sensor (2) in brake pad.
Attach the cable of the brake pad wear sensor in the holder (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Attach cable of brake pad wear sensor in holders (1).
Connect connectors (2) and lock.

Courtesy of BMW OF NORTH AMERICA, INC.
Close the cover (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Install the wheel arch cover in area (1).
Insert removed nuts and tighten.

TIGHTENING TORQUES SPECIFICATION

Wheel arch cover
Thermoplastic hexagon screw	Tightening torque	2.6 Nm
<Plastic nut	Tightening torque	2.6 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work