Installing the bearing bracket for the pedal mechanism
- Install bearing bracket (2).
- Replace the screw (1).
Parts: Screw
- Position and tighten the screw (1).
TIGHTENING TORQUES SPECIFICATION
| Pedal bracket on body | ||
|---|---|---|
| M8 Replace screw. |
tightening torque | 22 Nm |
- Replace nuts (1).
Parts: Nuts
- Install the nuts (1) and tighten.
TIGHTENING TORQUES SPECIFICATION
| Brake booster to pedal assembly console Replace nuts. |
||
|---|---|---|
| M8 Retighten 1x on brake booster after 10 min. |
tightening torque | 22 Nm |
NOTE:
The following step(s) must be performed if the listed component(s) is/are installed.
- Connect connector (1).
NOTE:
The following step(s) must be performed if the listed component(s) is/are installed.
- Connect connector (1).
- Lock brake pedal (1) in place in the arrow direction with the brake booster.
- Make sure that the brake pedal is completely locked with the brake booster!
Follow-up work
- Refer to INSTALLING BRAKE LIGHT SWITCH .
- Refer to INSTALLING THE TRIM PANEL FOR THE PEDAL ASSEMBLY .