Installing front brake caliper (high brake)
- Install the brake caliper in the arrow direction.
- Replace screws (1)
.
Parts: Screws
- Tighten down screws (1) .
TIGHTENING TORQUES SPECIFICATION
| Brake caliper/brake anchor plate at front swivel bearing | ||
|---|---|---|
| M12 Replace screw. |
Tightening torque | 130 Nm |
- Fit and tighten brake hose (1) on brake caliper.
If necessary, grip at knurling (2) .
TIGHTENING TORQUES SPECIFICATION
| Brake hose to brake caliper, front | |
|---|---|
| tightening torque | 17 Nm |
- Make sure the brake hose is not twisted and resting on components attached to the body.
- If necessary, hook the brake hose in the holder (3) .
Follow-up work
- Refer to GREASE BRAKE PADS, BRAKE ANCHOR PLATE AND BRAKE CALIPER WITH BRAKE PAD PASTE .
- Refer to INSTALLING FRONT BRAKE PADS .
- Refer to PLACING THE BRAKE PADS ON THE BRAKE DISK/PUTTING THEM INTO OPERATION .
- Refer to ADHESION OF BRAKE PADS TO BRAKE PISTONS .
- Refer to INSTALLING THE FRONT BRAKE PAD WEAR SENSOR .
- Refer to INSTALLING THE FRONT LEFT AND RIGHT WHEELS .
- Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
- Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to FLUSHING AND BLEEDING FRONT BRAKES (AFTER PART EXCHANGE) .
- Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to COMMISSIONING/BEDDING IN (BRAKE) NEW BRAKE PADS AND BRAKE DISCS .