Install hydraulic unit

Protect the working area from escaping hydraulic fluid.
Insert the hydraulic lines in the locking plate (2) and hydraulic unit according to the mark.
Shift the locking plate (2) in arrow direction.

Tighten down screws (1).

TIGHTENING TORQUES SPECIFICATION

Locking plate to hydraulic unit
Screw	tightening torque	6 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Connect the hydraulic unit with all connectors and store level in the luggage compartment.
Connect the convertible top module (1).
Close trunk.
Fully open and close the convertible top 2 times.

Courtesy of BMW OF NORTH AMERICA, INC.

Check
Store the hydraulic unit (1) level.
Open and close convertible top at least 2 times.
With the convertible top closed, the oil level must be within the mark (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Result

» Oil level outside of the mark (2).

Measure
- Undo the screw (3) and correct the oil level.
Insert the hydraulic unit into the sound insulation (2).
Secure cable tie (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Feed in hydraulic unit (2) and position it.
Feed in foam backing (1) and position it.

Courtesy of BMW OF NORTH AMERICA, INC.
Insert existing connectors on the control unit (1) and lock them.
Feed in control unit (1) and position it.
Connect connectors (2) and lock.

Courtesy of BMW OF NORTH AMERICA, INC.
Close the retaining strap (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Feed in foam backing (2) and position it.
Insert the control unit (1) into the foam backing (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Insert the control unit (1) into the foam backing (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work