Checking the adjustment of the panorama glass roof

Check if the distance of the panorama glass roof lid to the roof is the same at the front and rear.
Insert special tool 0 493 687 (00 9 340) between the seal (1) and the panorama glass roof lid (2).
The resistance when moving the special tool must be the same at the front and rear.

Courtesy of BMW OF NORTH AMERICA, INC.
Make sure that the front panorama roof cover lies flush with the roof outer skin and is lower by a maximum of dimension (a).

Make sure that the rear panorama roof cover lies flush with the roof outer skin and higher by a maximum of the dimension (a).

G15652430

Courtesy of BMW OF NORTH AMERICA, INC.

TECHNICAL DATA SPECIFICATION

Gap dimension roof outer skin to glass slide/tilt sunroof panel
1 roof outer skin; 2 glass slide/tilt sunroof panel	a 0.6_-0.75^+0.75 mm
Courtesy of BMW OF NORTH AMERICA, INC.

TECHNICAL DATA SPECIFICATION

Gap dimension glass slide/tilt sunroof panel to roof outer skin
1 glass slide/tilt a sunroof panel; 2 roof outer skin	a 0.6_-0.75^+0.75 mm
Courtesy of BMW OF NORTH AMERICA, INC.

Measure the height of the panorama glass roof lid (1) to the roof (2) with the special tool 0 495 259 (51 0 010) .

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INITIALIZING PANORAMA GLASS ROOF .
Refer to INSTALLING SEALING RING FOR THE PANORAMIC ROOF INSIDE .