Install roller sunblind

• Extend the roller sunblind electrically by approximately 10 cm.

  Disconnect the plug connection on the roller sunblind to interrupt the extension of the roller sunblind.

• Insert the roller sunblind into the rear deck from the bottom.
• Press together the rear groove (1) and the front guide (2) a little and feed into the rear groove (1) on the rear deck.
• Feed in the front guide (2).
• Check the rear groove (1) and the front guide (2) for correct fit.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Clip in the cable clip (2).
• Connect the plug connection (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Check the protective caps (1) on the left and right for damage and replace as needed.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Insert the protective cap (1) on the left and right at the rear first and then clip in at the front.

  Make sure the protective caps (1) are clipped in and fitted correctly.

• After installing the rear deck with the roller sunblind and bolting it to the body, (completely) extend and retract the roller sunblind 5 times and test it for correct function.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE TRIM PANEL FOR THE STORAGE SHELF .
• Refer to INSTALLING THE REAR LEFT AND RIGHT TWEETERS .
• Refer to INSTALLING THE C-PILLAR TRIM PANEL ON THE LEFT AND RIGHT .
• Refer to INSTALLING THE LEFT AND RIGHT SEAT BELT FINISHER STRIP .
• Refer to INSTALLING BOTH BACKREST SIDE SECTIONS .