Installing the left and right A-pillar trim panel
NOTE:
Description is for left component only. Procedure on the right side is identical.
Install A-pillar trim panel
WARNING:
Airbag unit
.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- Before performing any work on the airbag, always disconnect the battery ground lead from the battery.
- Airbag unit may only be set down with the cushion (airbag itself) facing upwards.
- For additional information see: SAFETY REGULATIONS ON HANDLING AIRBAG SYSTEM COMPONENTS/GAS GENERATORS .
WARNING:
Pyrotechnic components
.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.
- Replace any damaged part or ones that have been dropped.
- For additional information see: SAFETY REGULATIONS ON HANDLING AIRBAG SYSTEM COMPONENTS/GAS GENERATORS .
- Check the clips (3) for damage and replace if necessary.
- Insert the A-pillar trim panels (2) and clip in with the clips (3).
- Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| A-pillar trim panel to body | ||
|---|---|---|
| Combination clamping screw with ISA | Tightening torque | 2.5 Nm |
Follow-up work