Installing the rear module bracket

Check 

• Check the seal (1) on the rear module bracket for damage.

Courtesy of BMW OF NORTH AMERICA, INC.

Result 

Seal (1) on the rear module bracket is damaged.

Measure

• Replace the rear module bracket.

• Check that bolt (1) has firm fit, tighten if necessary.
  TIGHTENING TORQUES SPECIFICATION
  
  

  Bolt to window regulator
  bolt	tightening torque	9.5 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Install the rear module bracket (2) and tighten screws (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Module bracket on inner door panel
  Oval-head screw M6	tightening torque	9 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten the nuts (1) with the special tool 0 496 726 (51 0 400)  .
  TIGHTENING TORQUES SPECIFICATION
  
  

  Module bracket on power window
  Hexagon nut	tightening torque	10 Nm

• Clip the door wiring harness to the back of the module bracket.
• Connect and lock the plug of the door wiring harness to the back of the module bracket.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE LOUDSPEAKER ON THE REAR DOOR .
• Refer to INSTALLING REAR DOOR TRIM PANEL .