Replacing the rear bumper cover

NOTE: Perform the steps on the right and left side.

Unclip the clamp (2).
Release locks (1) and remove cover (3).

Courtesy of BMW OF NORTH AMERICA, INC.
Detach the retaining lugs (1).
Remove the ultrasonic sensor (2) with the vehicle wiring harness.
Perform the steps on all other ultrasonic sensors.

Courtesy of BMW OF NORTH AMERICA, INC.
Check decoupling ring (1) for damage and, if necessary, replace it.
The decoupling ring must not be missing.

Courtesy of BMW OF NORTH AMERICA, INC.
Replace the rear bumper cover.
Parts: Bumper cover
Clip ultrasonic sensor (2) with the wiring harness into retaining lugs (1) of the rear bumper cover.
Perform the steps on all other ultrasonic sensors.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Perform the steps on the right and left side.

Courtesy of BMW OF NORTH AMERICA, INC.