Remove The Outer Section Of The B-Pillar
- Mark the separating cut (1) in accordance with the dimension (a) and disconnect. Thereby disconnect only the outer panel.
Dimension (a) =180 mm from the edge of the roof frame.
- Mark and cut the separating cuts (1) and (2) according to the specified dimensions.
Thereby disconnect only the outer panel.
Dimension (a) =125 mm from the center of the hole with '0 20 mm.
Dimension (b) = 25 mm from the center of the hole with '0 20 mm.
- Open welded connections in area (3).
- Loosen welded connections in areas (1).NOTE: TECHNICAL INFORMATION
For additional information see: 41 00... Releasing bonded connections - Open spot-welded adhesive joints in areas (2).
- Release the outer section of the B-pillar from the cavity sealing (3) and remove.