Installing the selector lever
- Position the selector lever (1) .
- Replace the screw (2)
.
Parts: Screw
- Tighten down screw (2)
.TIGHTENING TORQUES SPECIFICATION
Selector lever on gear selector switch Screw Tightening torque 0.8 Nm - Position the ribbon cable (1) correctly on the selector lever (arrows).
- Lock the connector (2)
in the arrow direction.
- Replace the trim (1)
.
Parts: trim
- Position the trim (1)
on the gearshift lever knob (2)
and lock in place.
Snap-in lugs must engage audibly.