Replace bumper cover, front

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Perform the steps on the right and left side.

Release the air inlet trim from the detents (1) and remove.

Courtesy of BMW OF NORTH AMERICA, INC.
Unlock the detents (1) and remove the ultrasonic sensor (2) upwards.
Perform the steps on all other ultrasonic sensors.

Courtesy of BMW OF NORTH AMERICA, INC.
Detach the spoiler edge (1) from the front bumper cover.

Courtesy of BMW OF NORTH AMERICA, INC.
Replace the front bumper cover.
Parts: Bumper cover
Position spoiler edge (1) and attach the front bumper cover.

Courtesy of BMW OF NORTH AMERICA, INC.
Check decoupling ring (1) for damage and, if necessary, replace it.
The decoupling ring must not be missing.

Courtesy of BMW OF NORTH AMERICA, INC.
Guide in ultrasonic sensor (2) and lock it in place into locks (1).
Perform the steps on all other ultrasonic sensors.

Courtesy of BMW OF NORTH AMERICA, INC.

Check
Check detents (1) for damage.

Courtesy of BMW OF NORTH AMERICA, INC.

Result

» Detent is damaged.

Measure
- Replace the bumper cover.
Position the air inlet trim on the front bumper cover and clip in locks (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Guide in tether.
Position the cover of the towing eye (1) and clip in with the detents (2).

Courtesy of BMW OF NORTH AMERICA, INC.