Remove receiver for radio remote control
Precondition
- Convertible top is open.
Convertible top compartment lid is in the open position.
Wind deflector is removed.
Rear seat backrest is folded.
Preliminary work
- Refer to REMOVING LUGGAGE COMPARTMENT FLOOR COVERING .
- Refer to REMOVING THE LOADING EDGE TRIM .
- Refer to LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL .
- Refer to REMOVING REAR SEAT BENCH .
- Refer to REMOVING THE SEAT BELT FINISHER STRIP .
- Refer to REMOVING REAR SIDE TRIM PANEL .
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to REMOVING THE TOP PARTITION PANEL TRIM PANEL .
- Loosen expanding rivet (1) .
- Disconnect the connector (2) .
- Remove the receiver for the radio remote control (3) .