Installing engine wiring harness section/DME

Overview graphic of the wiring harness section for the engine/DME 

Courtesy of BMW OF NORTH AMERICA, INC.

• Feed in and position the vehicle wiring harness (3)  .
• Position the eyelet (4)  .
• Tighten down screw (2)  .
  TIGHTENING TORQUES SPECIFICATION
  
  

  Ground connection on cylinder head cover
  M6x14 screw	tightening torque	10 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Fix wiring harness fasteners (1)  .
• Clip in the wiring harness (2)  in area of holder (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the eyelet (3)  .
• Tighten nut (2)  .
  TIGHTENING TORQUES SPECIFICATION
  
  

  Ground cable to hold-down device
  Nuts	Tightening torque	5.5 Nm

• Fasten the clip (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Fix wiring harness fasteners (2)  .
• Connect and lock the plug connections (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING ALTERNATOR .
• Refer to CONNECTING THE COOLANT LINES OF THE EXHAUST TURBOCHARGER .
• Refer to INSTALLING CLEAN AIR PIPE OF CYLINDER BANK 1 .
• Refer to INSTALLING THE CLEAN AIR PIPE OF CYLINDER BANK 2 .
• Refer to ATTACHING THE CHARGE AIR COOLER .
• Refer to CONNECTING THE LEFT CHARGE AIR LINE TO THE EXHAUST TURBOCHARGER .
• Refer to CONNECTING THE RIGHT CHARGE AIR LINE TO THE EXHAUST TURBOCHARGER .
• Refer to INSTALLING FRONT STIFFENING PLATE AND/OR UNDERBODY PROTECTION OF THE STEERING GEAR .
• Refer to INSTALLING THE UNDERBODY PROTECTION OF THE STEERING GEAR OR THE FRONT THRUST FIELD .
• Refer to INSTALLING FRONT UNDERBODY PROTECTION .
• Refer to INSTALLING THE BOTTOM FRONT RIGHT SIDE COVER .
• Refer to CLOSING THE HIGH-TEMPERATURE COOLANT CIRCUIT .
• Refer to INSTALLING DRIVE BELT .
• Refer to PARTIALLY FASTENING THE COOLANT EXPANSION TANK FOR THE LOW-TEMPERATURE COOLANT CIRCUIT .
• Refer to INSTALLING FAN COWL .
• Refer to INSTALLING THE CONTROL UNIT BRACKET FOR CYLINDERS 5 TO 8 .
• Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
• Refer to INSTALLING UPPER CROSS CONNECTION .
• Refer to INSTALLING BOTH FRONT-END STRUTS .
• Refer to INSTALLING THE CENTER ENGINE COMPARTMENT COVER .
• Refer to CONNECTING ALL BATTERY GROUND LEADS .
• Refer to INSTALLING THE COVER OF THE LEFT DME CONTROL UNIT .
• Refer to FILLING AND VENTING THE HIGH-TEMPERATURE COOLANT CIRCUIT .