Installing the crankshaft sensor

• Guide in and install crankshaft sensor (2) and install.
• Tighten down screw (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Crankshaft sensor to crankcase
  TS5x20	tightening torque	6 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect connectors (1) and lock.

  The connector (1) must engage audibly.

  Courtesy of BMW OF NORTH AMERICA, INC.

• With automatic transmission: 

  Insert and install the holder (2).

  Make sure that the holder (2) is installed correctly in the guide (3).

  Position the transmission oil line 4 on the bracket 2.

  Secure clamps (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• With automatic transmission: 
• Tighten down screw (3).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Holder on end cover
  M6X16	Tightening torque	8 Nm

• Insert and position the holders (2).
• Replace the screw (1).

  Parts:  Screw

• Tighten down screw (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Holder for transmission oil line
  Screw	Tightening torque	4 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE STIFFENING PLATE .
• Refer to INSTALLING UNDERBODY PROTECTION AT REAR .
• Refer to INSTALLING THE UNDERBODY PROTECTION OF THE STEERING GEAR OR THE FRONT THRUST FIELD .