Install guide for rear center bumper
- Position the guide for the center rear bumper (1).
NOTE:
Perform the steps on the right and left side.
- Tighten down screw (2).
- Tighten nuts (1).
TIGHTENING TORQUES SPECIFICATION
| Guide for rear bumper at center on body | ||
|---|---|---|
| Nut and washer assembly with paint scrape groove | Tightening torque | 5 Nm |
| Hexagon screw for thermoplastic | Tightening torque | 3 Nm |
NOTE:
To provide a better overview: Schematic diagram with partially hidden components.
- Clip in clips (1).
- Clip in clamp (2).
- Clip in the connector housing (3).
- Clip in clamp (1).
- Clip in the clip (2).
Follow-up work
- Refer to INSTALLING THE GUIDE FOR THE REAR BUMPER .
- Refer to IF INSTALLED: INSTALLING LANE CHANGE WARNING SENSOR .