Installing transmission cross member

• Install transmission cross-member.
• Tighten down screw (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Transmission cross member to rubber mounts
  M12	tightening torque	68 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screws (2).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Transmission cross member to body
  M8	tightening torque	19 Nm

• Remove the transmission jack.

Follow-up work 

• Refer to INSTALLING UNDERBODY PROTECTION AT REAR .