Securing the anti-roll bar link on the left and right to the anti-roll bar
NOTE:
Perform the steps on the right and left side.
Securing the anti-roll bar link to the anti-roll bar
- Position the anti-roll bar link (3) on the anti-roll bar (2).
- Replace nut (1).
Parts: Nut
- Tighten nut (1).
NOTE:
Counter-hold at the Torx socket.
TIGHTENING TORQUES SPECIFICATION
| Anti-roll bar link to anti-roll bar | ||
|---|---|---|
| M12 Replace nut. |
tightening torque | 100 Nm |
Follow-up work
- Refer to FASTENING THE WIRING HARNESS OF THE ACTIVE STABILIZER .
- Refer to INSTALLING THE UNDERBODY PROTECTION OF THE STEERING GEAR OR THE FRONT THRUST FIELD .
- Refer to INSTALLING THE COVER OF THE STEERING ASSEMBLY ON THE RIGHT .
- Refer to INSTALLING THE FRONT SECTION OF THE FRONT RIGHT WHEEL ARCH COVER .
- Refer to INSTALLING THE FRONT RIGHT WHEEL .
- Refer to FOR REPLACEMENT: PROGRAMMING/CODING THE ACTIVE STABILIZER .