Installing the rear ride height sensor
- Position ride height sensor (2) on holder.
- Tighten the screws (1).
TIGHTENING TORQUES SPECIFICATION
| Ride height sensor to holder | ||
|---|---|---|
| M5 | tightening torque | 5 Nm |
- Position jointed rod on the ride height sensor lever.
- Tighten nut (2).
TIGHTENING TORQUES SPECIFICATION
| Jointed rod to ride height sensor | ||
|---|---|---|
| M6 | tightening torque | 8 Nm |
- Connect the connector (1) on the ride height sensor.
Follow-up work
- Refer to INSTALLING THE COVER OF THE CAMBER CONTROL ARM .
- Refer to CARRYING OUT RIDE HEIGHT ADJUSTMENT .
- Refer to RESETTING THE TIRE PRESSURE MONITOR .
- Refer to ADJUSTING HEADLIGHTS .