Remount ride height sensor, front
- Release nut (3) and remove jointed rod (4) .
- Release screws (2)
and remove holder from ride height sensor (1)
.
- Position holder on new ride height sensor (1) .
- Tighten down screws (2) .
TIGHTENING TORQUES SPECIFICATION
| Ride height sensor to holder | ||
|---|---|---|
| M5 | tightening torque | 5 Nm |
- Position jointed rod (4) .
- Tighten nut (3) .
TIGHTENING TORQUES SPECIFICATION
| Jointed rod to ride height sensor | ||
|---|---|---|
| M6 | tightening torque | 8 Nm |