3112 Wishbone And Strut With Rubber Mount
3112 TIGHTENING TORQUE OVERVIEW
| Bottom wishbone on spring strut holder | ||
| M14 Replace screw and nut. Tighten screw connection in normal position! |
Joining torque | 165 Nm |
| Angle of rotation | 90° | |
| Lower wishbone to front axle carrier | ||
| M14 Replace screw and nut. Tighten in normal position. |
Joining torque | 85 Nm |
| Angle of rotation | 180° | |
| Tension strut to front axle support | ||
| M14 Replace flat nuts and screw. Tighten in normal position. |
Joining torque | 85 Nm |
| Angle of rotation | 180° | |
| Tension strut to swivel bearing | ||
| M16 Replace nut. |
Joining torque | 100 Nm |
| Angle of rotation | 90° | |
| Upper wishbone to body | ||
| M10 Replace screw and nut. |
tightening torque | 54 Nm |
| Upper wishbone to swivel bearing | ||
| M10 Replace screw and nut. |
Tightening torque | 56 Nm |
| Wheel control joint to wishbone | ||
| M16 Replace nut. |
Joining torque | 100 Nm |
| Angle of rotation | 90° | |
| Wheel guide joint to swivel bearing | ||
| M30 Replace nut. |
tightening torque | 380 Nm |