Install the active stabilizer
- Feed in the active stabilizer (1) on the right retainer (2).
- Position both upper sections of the anti-roll bar bracket and the left retainer (4) on the active stabilizer.
- Replace screws (2) and (3).
Parts: Screws
- Tighten down screws (2) and (3).
Since the screws have different lengths, the installation position must be maintained!
Screws (2) = M12x89
Screws (3) = M12x50
TIGHTENING TORQUES SPECIFICATION
| Anti-roll bar to front axle support | ||
|---|---|---|
| M12 Replace screws. |
Joining torque | 100 Nm |
| Angle of rotation | 45° | |