Observing the hardening time of the screw locking agent on the screw plug
NOTE:
TECHNICAL INFORMATION
A hardening time of 24 h must be observed after wetting the screw with the screw locking agent.
During the hardening time, the engine must not be started.
Filling the coolant circuit is only permitted after the hardening time.
A hardening time of 24 h must be observed after wetting the screw with the screw locking agent.
During the hardening time, the engine must not be started.
Filling the coolant circuit is only permitted after the hardening time.
- Observe the hardening time.
The high-temperature coolant circuit is not allowed to be filled during the hardening time.
- Observe the hardening time.
It is not allowed to start the engine during the hardening time.