Secure rear brake caliper
- Detach and remove the special tool 2 413 317
.
Do not hang the brake caliper (1) from the brake hose.
- Position the brake caliper (4) on the wheel carrier in the arrow direction.
Make sure that the brake hose is not twisted when positioning.
- Replace screws (3).
Parts: Screws
- Tighten down screws (3).
TIGHTENING TORQUES SPECIFICATION
| Brake anchor plate to rear wheel carrier | ||
|---|---|---|
| M12 Replace screw. |
Tightening torque | 130 Nm |
- Secure the brake hose (1) on the holder (2).