Removing the window recess finisher strip at the rear right on the outside

NOTE: Description is for left component only. Procedure on the right side is identical.

Removing the rear outer window recess finisher strip

Precondition

Side window glass is open.

NOTE: RISK OF DAMAGE
Damage of high-quality surfaces.
Plastic wedges can damage high-quality surfaces.

Insert special tool 0 495 484 (00 9 324) into window cavity.
Position the special tool 0 495 484 (00 9 324) as shown with the short shank at the lower edge of the window recess finisher strip (1).
Position the special tool 0 496 570 (00 9 326) on the side trim panel.
To avoid pressure points on the side trim panel from the special tool 0 496 570 (00 9 326) , also protect the side trim panel.
Thread a suitable tool (2) through the opening in the special tool 0 495 484 (00 9 324).

Courtesy of BMW OF NORTH AMERICA, INC.
Gradually shift special tool 2 298 505 and 0 495 484 (00 9 324) backwards until the window recess finisher strip (1) has been completely lifted off.
Release and remove the window recess finisher strip (1) from the clips (2).

Courtesy of BMW OF NORTH AMERICA, INC.