Install engine ventilation line

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2025 BMW X4, 2024 BMW X4, 2023 BMW X4, 2022 BMW X4, and 2021 BMW X4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: RISK OF DAMAGE
Improper routing of cables and wiring harnesses.
Trapped, crushed or damaged cables may cause short circuits and malfunctions.

Route all cables without abrasions, do not trap and crush.

NOTE: TECHNICAL INFORMATION
Check the retaining lug on the connector for damage and perform a tension check as needed.

Check the sealing ring (1) for damage and replace the tank ventilation line if necessary.

Courtesy of BMW OF NORTH AMERICA, INC.

Insert and position the engine ventilation line (2).
Insert and install the tank vent line (1).
The tank vent line (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.
Insert and install the engine ventilation line (3).
Make sure that the locks (1) and (2) snap-in audibly.

Courtesy of BMW OF NORTH AMERICA, INC.
Feed in and position the wiring harness section of sensor system 2 (4).
Connect connectors (2) and lock.
Connect connectors (1) and lock.
The connectors (1) and (2) must engage audibly.
Secure clamps (3).

Courtesy of BMW OF NORTH AMERICA, INC.

Feed in and install the heat protection (2).
Lock the locks (1).
Locks (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

INSTALLING INTAKE FILTER HOUSING .
Refer to INSTALLING THE RIGHT FRONT-END STRUT .
Refer to INSTALLING ACOUSTIC COVER .