Check the high-temperature cooling system for watertightness
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2025 BMW X4, 2024 BMW X4, 2023 BMW X4, 2022 BMW X4, and 2021 BMW X4. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
- Loosen sealing cap (1).
- Mount the special tool 0 494 418 (17 0 101) with 0 494 419 (17 0 102) and 0 494 420 (17 0 103) from the set of special tools 0 494 417 (17 0 100).
- Build up excess pressure and wait for approximately 2 minutes.TECHNICAL DATA SPECIFICATIONS
Opening pressure of sealing cap/test pressure of cooling system of high-temperature coolant circuit Pressure relief valve opens when the pressure exceeds the ambient pressure. min. 1.4 bar Electric changeover valve must open at latest when the pressure is lower than the ambient pressure max. 0.1 bar Test pressure for cooling system (gauge pressure) 1.5 bar NOTE: TECHNICAL INFORMATION
If the described test step is not completed successfully: repeat test step twice. Only replace the sealing cap after three tests with an incorrect opening pressure.
When driving at high ambient temperatures, the design may cause the pressure relief valve in the sealing cap to open slightly and air to leakage together with dissolved coolant. This coolant vapor condenses on the surface of the coolant expansion tank and leaves traces of coolant when the vehicle has cooled down. These traces of coolant do not indicate whether the sealing cap is defective or not.
Leakage coolant vapors when the vehicle is at standstill may cause the pressure relief valve to stick to the sealing cap. This may cause an incorrect opening pressure. - Screw on sealing cap (1) on special tool 0 494 643 (17 0 114) from the set of special tools 0 494 417 (17 0 100) .
- With special tool
- Observe on the pressure tester when the opening pressure has been reached.TECHNICAL DATA SPECIFICATIONS
Opening pressure of sealing cap/test pressure of cooling system of hightemperature coolant circuit Pressure relief valve opens when the pressure exceeds the ambient pressure. min. 1.4 bar Electric changeover valve must open at latest when the pressure is lower than the ambient pressure max. 0.1 bar Test pressure for cooling system (gauge pressure) 1.5 bar - Close sealing cap (1).
- Close the sealing cap (1) until the arrows are flush.